The Riquianez Viaduct (Las Palmas de Gran Canaria)

Bridges and Viaducts · Continuous or Girder Bridges

Riquianez Viaduct (Las Palmas de Gran Canaria)

Back to list
Viaducto de Riquianez (Las Palmas de Gran Canaria) – foto 2Viaducto de Riquianez (Las Palmas de Gran Canaria) – foto 3Viaducto de Riquianez (Las Palmas de Gran Canaria) – foto 4Viaducto de Riquianez (Las Palmas de Gran Canaria) – foto 5Viaducto de Riquianez (Las Palmas de Gran Canaria) – foto 6

Project description


The Riquianez viaduct is located on the Las Palmas de Gran Canaria Ring Motorway, Phase III, "Picoviento–Jinámar" section, carrying its two carriageways over the ravine from which it takes its name.

The viaduct consists of two decks, one for each carriageway, each 14.0 m wide, accommodating 3 lanes of 3.50 m, a 1.50 m outer shoulder and a 1.20 m inner shoulder, plus two 0.40 m side strips carrying the safety barriers.

In plan, the alignment is a circular curve with a radius of 498.0 m. In elevation, it lies on a sag curve with parameter kv = 12000. The crossfall is a constant 8%.

After a study of alternatives, a prestressed concrete single-cell box girder was chosen, with a constant depth of 2.60 m and the following spans:

- 37.95+5 x 47.45+37.95 for the left deck (total length 313.15 m)

- 36.85+6 x 46.06+36.85 for the right deck (total length 350.10 m)

The box webs are 0.40 m thick and the top and bottom slabs 0.25 m. The section is completed by two 3.20 m cantilevers with a depth varying between 0.17 m and 0.50 m.

Incremental launching from one of the abutments was chosen as the construction method.

The piers have a single shaft supporting both decks through a trapezoidal cap beam at the top. Only the last pier of the longer deck is a simple pier, as it supports only one deck and is aligned with the abutment of the other carriageway. The pier heights range from 31.3 to 67.3 m. They are hollow, with 0.35 m thick walls. The piers have spread footings, except pier 5, which is founded on a group of micropiles.

The abutments are closed, with return wing walls, on spread footings. All bearings are confined elastomeric POT bearings.