The Saramo Viaduct (A Coruña)

Bridges and Viaducts · Continuous or Girder Bridges

Saramo Viaduct (A Coruña)

Back to list
Viaducto de Saramo (A Coruña) – foto 2Viaducto de Saramo (A Coruña) – foto 3Viaducto de Saramo (A Coruña) – foto 4Viaducto de Saramo (A Coruña) – foto 5Viaducto de Saramo (A Coruña) – foto 6Viaducto de Saramo (A Coruña) – foto 7

Project description


The new Ourense–Santiago high-speed line, in the Vedra–Boqueixón section, crosses the valley of the Saramo River with a maximum height of about seventy metres.

The viaduct is 1,485 m long. It is curved in plan with a 6,000 m radius and has a gradient of 0.74%. Its deck has 26 spans: 46.40+24x58.0+46.40 m. Its layout meets the environmental requirements imposed by the river banks and the road, as well as by the presence of the "Hórreo de Sergude", a listed monument.

The fixed point of the deck is at pier 20, designed as an "A"-shaped triangular cell fixed to the deck. The viaduct has expansion joints at both abutments.

It consists of a post-tensioned concrete continuous box girder with a depth varying from 4.85 to 3.25 m. The central 34.8 m of each span has a constant depth. The section is a single-cell box with inclined webs, a bottom width varying from 5.50 to 6.56 m, a constant top width of 8.50 m and two 2.75 m side cantilevers completing the total width of 14 m.

The main deck prestressing consists of 37-strand tendons running along the box webs.

All the piers (except pier 20) are hollow octagons with 0.30 m thick walls, a constant width of 5.50 m and a variable depth with a minimum of 2.30 m at the top. Their heights range between 11.3 and 69.6 m.

Pier 20 is special, as it is the fixed point of the deck. It is A-shaped, with two box-section arms of 2.30x5.50 m that converge and are fixed to the deck. The pier footing is hollow and contains an earth fill that ensures its stability. The two pier arms are prestressed and anchored in the deck and the footing.

The abutments are conventional, closed, reinforced concrete abutments. The first abutment is the fixed point of the deck during part of its construction.

The deck rests on the piers and abutments through pairs of sliding POT bearings, one free and one guided.

The deck was built with a self-launching movable scaffolding system.